Where can I find a prismaster?

[Bigblue1]

You do realize the prismaster comes apart right? I clean mine out after every pack. Just slide the inside piece out, and rinse with water. Not hard at all.

No I didn't, thanks. Not that i ever use mine, except when I'm doing something that dirties my hands, and to wash is not feasible. ie fishing working on a car and such.

[deadpool99]

I didn't know it came apart either. I just run water through it to clean it out. But now that I know it comes apart I'll be able to get it cleaner at least.

The syringes work its just that I didnt really care for it all that much. Im just a fan of purpose made tools.

[c.nash]

ICETOOL!

JUST GET AN ICETOOL...


Honestly. Icetools are like the lös tools of the gods.

[krahv]

I used syringe before, but my icetool arrived today wich i got from snusauction for 26$. Before i got it i didnt think theres much difference beside looks, cause they work pretty much same.
But theres world of difference, icetool makes pris so much better and it keeps good in mouth too.

Only bad side effect i dont like in icetool other than the price, is that it gets stuck if it stays put for some time. Pretty annoying to pull it when theres hot and you sweat alot other than that pretty nice accessory

[c.nash]

Just oil her up.

Never had mine stick.

[desirexe]

Just oil her up.

Never had mine stick.

This should be added to a 'Member Quote' thread.

[LaZeR]

This should be added to a 'Member Quote' thread.

I couldn't even touch that one. Had to look away...

[krahv]

I did oiled it, it works fine then, but when i leave it for an hour or so, its stuck again until i get it movin again.
I think its just too new .. I mean i have use it just 4 times and havent broken it in yet ?

[lxskllr]

Only bad side effect i dont like in icetool other than the price, is that it gets stuck if it stays put for some time. Pretty annoying to pull it when theres hot and you sweat alot other than that pretty nice accessory

It'll break in over time. When mine was new, I oiled it once per week or so. Now almost never. The only reason I do it anymore is for something to do for a couple minutes :^D

Edit:

It'll take about a year before it gets really nice, but it'll slowly wear into shape.

[LaZeR]

I did oiled it, it works fine then, but when i leave it for an hour or so, its stuck again until i get it movin again.
I think its just too new .. I mean i have use it just 4 times and havent broken it in yet ?

What kind of oil do you use? I use Olive Oil on the O'ring only. Just dip my finger in the cap from the olive oil and lightly spread it around the ring.