How Do You Bake Your Pris?

[PrisMaster]

Sorry if this topic has been covered before, but I have just been wondering about this.

How do you bake your Pris? I know there are a few different shapes everyone specifically does so just looking to see what everyone usually makes theirs in to? Personally, I like making mine into a ball. Its pretty easy to bake into and holds together very well for me. I tend to keep my snus in for anywhere from a minimum of 2 hours to anywhere from 5 hours and sometimes longer depending on if I take it out for a little while during eating. So far a ball has worked awesome for me and I never have it break apart to much for me to where I have to toss it out.

So how do you bake?

[Soft Morning, City!]

I mostly use the Icetool, but when I bake by hand I tend to make either cylindrical or rectangular prillas. Sometimes it varies, but I usually stick to those two shapes.

[Xobeloot]

I am the same as Soft M.C. At work, I use my icetool. When I hand bake, I tend to make a cylinder (assuming that im working with something I can pack well). The rectangle tends to be my backup plan if I am working with a snus that falls apart when i start to round it out and press the ends. Maybe, with more practice, I will be able to make all of them cylindrical.

[lxskllr]

I shape mine like a flattened American football. Larger in the middle, with a gentle taper towards the ends.

[Zofryer]

I shape mine like a flattened American football. Larger in the middle, with a gentle taper towards the ends.

I've been doing the same thing on purpose, but mine end up hotdog shaped. I end up with a long pris that wraps almost back to my molars and terminates on the flap of skin up front. I push the pris up as high as it will go in my lip. I alternate sides, and keep em in for about two hours. I'm considering getting an icetool for initial shaping, but I'll probable end up making something to form my starter shape. And I can't really think of a reason to do it any differently. It's high enough in my lip to stay off my teeth. The surface area is HUGE so I get an insane nicotine buzz.

[PrisMaster]

I tried the cylinder shape a little more yesterday and today and it works pretty good. Not a big difference then making a ball like I usually do though. Usually when I make a ball and put it in it ends up flattening into a cylinder shape anyways.